Filter
Top Products
48 FSN Series • User’s Guide • Rev 01
2. FSN-1400 Orientation
Card Descriptions
cpk=pÉêáÉë=bíÜÉêåÉí=`çååÉÅíáçåë
This section provides information on all FSN Series Ethernet connections.
Figure 2-6. Basic system Ethernet diagram
• FSN-1400
The FSN-1400 has a single Ethernet port located on the System card. This port
connects to Ethernet Port 1 on the FSN-150 or FSN-250 control panel, either
directly or via an Ethernet switch. By default, the following conditions are set:
~ DHCP = OFF
~ Default IP address: 192.168.0.4
~ Default Netmask: 255.255.255.0
The user can use the default address, or set a different address.
• FSN-150 and FSN-250 control panels
Each control panel has two Ethernet ports located on the rear panel:
~ Ethernet Port 1 connects to the FSN-1400, either directly or via an
Ethernet Switch. By default, the following conditions are set:
• DHCP = OFF
• Default IP address: 192.168.0.5
• Default Netmask: 255.255.255.0
The user can use the default address, or set a different address.
~ Ethernet Port 2 can be connected to an outside network, or to your
facility’s “house” network. By default, the following conditions are set:
• DHCP = ON
An IP address can be obtained automatically from the outside network.
Use the Com Setup Menu to change IP addresses. In Chapter 6, refer to the
“Communications Setup
” section on page 285 for details.
Switch
FSN-150
Ethernet
FSN-1400
Ethernet Port 1