Filter
Top Products
FSN Series • User’s Guide • Rev 01 123
4. Installation
Signal Connections
2. Connect M/E 1 Preview Out to a monitor. This output provides the bank’s
“lookahead” preview video. In Chapter 7, refer to the “Understanding
Lookahead Preview” section on page 319 for additional information.
3. Connect M/E 1 Clean Out to a monitor or the desired destination. This output
provides M/E 1’s clean feed signal. In Chapter 2, refer to the “Clean Feed Output
Selection” section on page 52 for details.
Use the following steps to connect the FSN-1400’s M/E 2 outputs:
1. Connect M/E 2 Program Out to a monitor or the desired destination. This output
provides M/E 2’s program output signal.
2. Connect M/E 2 Preview Out to a monitor. This output provides the bank’s
“lookahead” preview video. In Chapter 7, refer to the “Understanding
Lookahead Preview” section on page 319 for additional information.
3. Connect M/E 2 Clean Out to a monitor or the desired destination. This output
provides M/E 2’s clean feed signal. In Chapter 2, refer to the “Clean Feed Output
Selection” section on page 52 for details.
Please note the following important points:
• On the FSN-150, M/E 2 control must be enabled to fully utilize the M/E 2 outputs.
In Chapter 7, refer to the “M/E 2 Control on the FSN-150” section on page 349
for details.
• All outputs run at the system’s selected native output resolution.
• In Chapter 6, refer to the “Reference Video and Output Setup” section on
page 287 for instructions on setting the native resolution.