Filter
Top Products
80 FSN Series • User’s Guide • Rev 01
3. Control Panel Orientation
Control Panel Descriptions
S BG + WIPE enabled — press AUTO TRAN to wipe from PGM to
PST.
S DSK + MIX enabled — press AUTO TRAN to mix the DSK on or off.
S BG + DSK + MIX enabled — press AUTO TRAN to mix from PGM
to PST, and simultaneously mix the DSK on or off.
Press AUTO TRAN during the transition interval to pause the transition. The
Transition LEDS indicate the point at which the transition is paused. Press
AUTO TRAN again to continue in the same direction. You can pause and
continue repeatedly.
7) FTB
The FTB (Fade to Black) button enables you to transition the switcher’s Program
output to black. Please note:
~ When pressed, the switcher fades to black, including the DSK. Once in
black, the FTB button blinks.
~ While in black, the PGM and M/E banks are fully functional, and
individual switcher outputs are fully functional (e.g., M/E 1 Out). Sources
can be preset on any bus, and any memory register can be recalled —
but the setups will not contribute to the switcher’s Program output.
~ When FTB is pressed again, the switcher fades up from black to the
current setup. If the DSK is enabled, it remains enabled.
~ Use the Transition Menu to change the FTB transition rate. The current
transition rate appears in the Transition Display. In Chapter 5, refer to
the “Transition Menu” section on page 148 for details
Note
Use the Transition Menu to change transition rates and
curves. Remember that the bank’s transition rate appears in
the Transition Display. In Chapter 5, refer to the “Transition
Menu” section on page 148 for details.
Note
You can use AUTO TRAN and the T-Bar together. For
example, you can start a transition manually, and continue it
automatically. In Chapter 7, refer to the “Working with
Mixes” section on page 331 for full details.
FTB
Note
When the switcher is in black, the button color of the source
selected on PGM changes to dim red.