Filter
Top Products
290 FSN Series • User’s Guide • Rev 01
6. System Setup
Clean Feed Setup
`äÉ~å=cÉÉÇ=pÉíìé
FSN Series system setup: Step 8
In this procedure, you can set clean feed outputs, and select a source for the
ASSIGN
button (in the control panel’s
Aux Section).
S Prerequisite — Ensure that you are familiar with the Clean Feed Setup
Menu. In Chapter 5, refer to the “Clean Feed Setup Menu” section on
page 232.
Clean Feed Setup — Use the following steps to set clean feed outputs:
1. In the Menu Bar, press {System} to access the System Menu.
2. Press {Clean Feed Setup} to display the Clean Feed Setup Menu.
3. Press {Clean Feed Outputs} to display the Clean Feed Outputs Chart.
4. On the chart, select the desired clean feed point for M/E 1’s clean feed output:
~ Press {M/E 1 Clean 1} to select the point prior to Keyer 1 on M/E 1.
~ Press {M/E 1 Clean 2} to select the point prior to Keyer 2 on M/E 1.
~ Press {M/E 1 Out} to select the point after Keyer 2 on M/E 1.
5. On the chart, select the desired clean feed point for M/E 2’s clean feed output:
~ Press {M/E 2 Clean 1} to select the point prior to Keyer 1 on M/E 2.
~ Press {M/E 2 Clean 2} to select the point prior to Keyer 2 on M/E 2.
~ Press {M/E 2 Out} to select the point after Keyer 2 on M/E 2.
6. Select the desired clean feed point for the PGM bank’s clean feed output:
~ Press {PGM Clean} to select the point prior to the DSK.
~ Press {PGM Out} to select the point after the DSK.
ASSIGN Setup — Use the following steps to select the clean feed source that is
mapped to the
ASSIGN button in the control panel’s Aux Section:
7. Press {Assign Button} to display the Assign Button Chart.
8. Select one of three mutually exclusive clean feed points for the button:
~ Press {M/E 1 Clean 1} to select the point prior to Keyer 1 on M/E 1.
~ Press {M/E 1 Clean 2} to select the point prior to Keyer 2 on M/E 1.
~ Press {M/E 2 Clean 1} to select the point prior to Keyer 1 on M/E 2.
~ Press {M/E 2 Clean 2} to select the point prior to Keyer 2 on M/E 2.
~ Press {PGM Clean} to select the point prior to the DSK.
Please note:
• The clean feed selection is global for all Aux routes. If you change the mapping
for one route, it changes for
all routes.
• To quickly display the Assign Button Panel, press and hold the ASSIGN button.
8