Filter
Top Products
FSN Series • User’s Guide • Rev 01 401
8. DVE Operations
Automatic DVE Triggering
rëáåÖ=^ìíçã~íáÅ=asb=qêáÖÖÉêë=
The following combinations of DVE triggers are discussed in this section:
• Trigger an Effect on Keyer 1 Only
• Trigger an Effect on Keyer 2 Only
• Trigger Effects on both Keyers
• Mix Key and Trigger an Effect on Keyer 1
• Mix Key and Trigger an Effect on Keyer 2
• Mix Key and Trigger Effects on both Keyers
• Mix BG and Keyer 1, and Trigger Effect on Keyer 1
• Mix BG and Keyer 2, and Trigger Effect on Keyer 2
• Mix BG and both Keyers, Trigger Effects on both Keyers
• Wipe Trigger Options
• Tap In, Tap Out Functions
qêáÖÖÉê=~å=bÑÑÉÅí=çå=hÉóÉê=N=låäó
Use the following steps to trigger a DVE effect on Keyer 1 only:
1. In the Next Transition Group, press KEY 1.
2. In the Effects Group, press FX TRIG. The label “FX” appears in the Transition
Display above KEY 1, indicating that the DVE effect is armed.
3. Press AUTO TRAN to run the effect forward or backward.
4. To cancel the trigger, press MIX or WIPE.
Figure 8-24. Trigger DVE effect on Keyer 1
Tip
On the control panel, practice each example below as you
read along.
BG
KEY
1
KEY
2
MIX WIPE
FX
TRIG
M E M F X K E Y 2 T R A N
2 1 C A M 1 G F X 2 3 0
Important
If KEY 1 is not enabled on Program (with the red “on air” LED
lit), you will not see the PIP flight occur, either on Preview or
Program.