Filter
Top Products
346 FSN Series • User’s Guide • Rev 01
7. Operations
Working with Aux Buses
tçêâáåÖ=ïáíÜ=^ìñ=_ìëÉë
The switcher’s Aux Section enables you to route input sources and selected outputs to
various “destinations.”
S Prerequisites
~ Ensure that you are familiar with mapping and naming Aux outputs. In
Chapter 6, refer to the “
Aux Setup” section on page 298 for instructions.
~ Ensure that you are familiar with the Aux Section on the control panel.
In Chapter 3, refer to the “
Aux Section” heading on page 91 for details.
Use the following steps to assign sources to Aux bus outputs:
1. Ensure that your Aux outputs are mapped and named to your satisfaction.
2. On the Aux Bus Row, select the Aux output that you want to assign.
3. On the Aux Source Row, select one of the following:
~ Select a new source or program output (e.g., PGM, M/E).
~ Select Black.
~ Select an output (e.g., M/E 1, PGM).
~ Select a clean feed source by pressing ASSIGN, and choosing the
desired source from the
Clean Feed Setup Menu. Refer to the
“
Selecting Clean Feed Outputs” section below for details.
4. Repeat the procedure from step 2 to make additional assignments.
Note
Remember that only one clean feed source can be mapped to
the
ASSIGN button for all Aux buses. For example, you
cannot map “
Pre KEY 1” to Aux 1, and “Pre KEY 2” to Aux 2.