Filter
Top Products
FSN Series • User’s Guide • Rev 01 145
5. Menu Orientation
Using the Keypad
register clears when you begin entering numbers, and digits shift left as you enter
them. You must press
{Enter} to complete an entry.
3) Backspace
Press Backspace {←} during a numeric entry process to clear the register by
one digit with each press.
4) Numerics
Press the numeric buttons {0 - 9} to enter values. Digits shift left in the Register
as you enter them. Use the {Decimal} button as required for entries that include
decimal values.
5) +/-
Press {+/-} to invert the numeric entry in the Register (if applicable). For
example, press
{+/-} to change +350 to -350.
6) Close
Press {Close} to clear the Keypad from the Touch Screen, and “un-latch” the
selected value button.
7) Undo
Prior to pressing {Enter}, press {Undo} at any point during the numeric entry
process to restore the original value, even if
{Clear} or {+/-} was pressed.
8) Clear
Press {Clear} during a numeric entry process to clear the register to 0 (zero).
9) Trim -
Enter an offset value using the numeric buttons, then press {Trim -} to subtract
from the parameter’s current value. Pressing
{Enter} is not required, and the
“trim” value remains in the register, enabling you to trim repeatedly by the same
offset. Once the value is trimmed, you can close the
Keypad, or perform addition
trims or entries in the normal way.
For example:
S To subtract 5 frames from a transition rate, press the Rate button for
the desired M/E, then in the
Keypad, press {5, Trim -}.
S To subtract 25 pixels from a mask value, press the desired mask
edge (e.g.,
{Mask Top}), then in the Keypad, press {25, Trim -}.
Note
The {+/-} button is only applicable when certain Keypad
functions that accept negative values are active.
Note
If you press {Close} prior to pressing {Enter}, {Trim +} or
{Trim -}, the Keypad clears, and the previous value is
maintained.
Note
If {Enter} is pressed, that value becomes the new value to
which the register will return, if
{Undo} is pressed.