Filter
Top Products
FSN Series • User’s Guide • Rev 01 149
5. Menu Orientation
Transition Menu
qê~åëáíáçå=jÉåì=^ÅÅÉëë
There are two ways to access the Transition Menu:
• In the Menu Bar, press {Page} to display page 1 (if required). Then, press the
{Trans} button.
• Press and hold any MIX button on the control panel (e.g., MIX in the M/E 1 bank
or the PGM bank).
qê~åëáíáçå=o~íÉ=^ÇàìëíãÉåí
Transition rates can be adjusted from 1 to 999 frames, in 1 frame increments. There are
two ways to adjust rates individually:
• Turn the Knob adjacent to the any value button to adjust the auto transition rate
(in frames) for that specific location (
M/E 1, M/E 1, PGM or FTB).
~ The value on the button changes as you adjust, and the associated
Transition Display (on the panel) updates.
~ Changes in rates take effect immediately.
• To “key in” an auto transition rate, press any value button to display the Keypad
for that specific location. Enter a new rate (in frames) and press
{Enter}, or trim
the current rate using
{Trim -} or {Trim +}.
You can also enter or trim all transition rates simultaneously:
• To set all rates to the same value, press {All/Set Trim}. All value buttons light.
Next, press any value button to display the keypad.
~ To set all rates to the value in the keypad’s register, press {Enter}.
~ To set all rates to a new value, enter the new value and press {Enter}.
• To trim all rates simultaneously as offsets to their current values, press {All/Set
Trim}. All value buttons light. There are two ways to trim the value:
~ Turn any Knob to increment or decrement all rates.
~ Press any value button to display the keypad. Enter the desired “trim”
value and press
{Trim +} or {Trim -} as desired.
M/E 1
30
All
Set/Trim