Filter
Top Products
86 FSN Series • User’s Guide • Rev 01
3. Control Panel Orientation
Control Panel Descriptions
~ All transition and arm capabilities for KEY 2 are identical to those for
KEY 1 — but apply to KEY 2 instead. The DVE prerequisites are also
identical — a DVE channel must be assigned to KEY 2 and a two-
keyframe DVE effect must be loaded.
The following rules apply to all three buttons in the Next Transition Group:
~ As you enable or disable buttons in the group, the selected layer appears
(or is removed) on the M/E’s Preview output.
~ At the end of a transition (either manual or automatic), all buttons that
were enabled in the group remain on. This allows you to transition back
to the previous look.
~ All three buttons in the Next Transition Group work in combination with
the M/E’s MIX, WIPE, CUT, FX TRIG, AUTO TRAN button and the T-Bar.
For example:
S If you arm BG and MIX, press AUTO TRAN to automatically mix to
the selected source.
S If you arm KEY 1, BG and WIPE, move the T-Bar to manually wipe
to the selected source plus key.
S If you arm BG and KEY 2, press CUT to cut to the selected source
and cut the key on or off.
S If you arm KEY 1 and FX TRIG, press AUTO TRAN to trigger the
two-keyframe DVE effect (that is loaded into the DVE channel
assigned to KEY 1).
S If you arm KEY 1, MIX and FX TRIG, press AUTO TRAN to trigger
the two-keyframe DVE effect and also mix the KEY 1 layer.
In Chapter 7, use the following section for reference:
~ Refer to the “Understanding Lookahead Preview” section on page 319
for additional information about lookahead preview functionality.
~ Refer to the “Understanding Switcher Layers” section on page 312 for
a discussion of video layers within the switcher.
~ In Chapter 8, refer to the “Automatic DVE Triggering” section on
page 396 for complete details.
4) Effects Group
The three buttons in the Effects Group indicate which effects are armed for the
next transition in the M/E.
Figure 3-16. Effects Group
To use the group, press the button(s) for the transition that you want to arm.
KEY
2
Note
The Key Menu can be used at any time to adjust key
parameters, whether or not the key is on. In Chapter 5, refer
to the “Keyer Menu
” section on page 157 for details.
MIX WIPE
FX
TRIG