Filter
Top Products
FSN Series • User’s Guide • Rev 01 423
9. Multiviewer Operations
Multiviewer Setup
jìäíáîáÉïÉê=pÉíìé
Comprehensive Multiviewer setup instructions are provided in Chapter 6. Refer to the
“
Multiviewer Setup” section on page 301 for complete details.
jìäíáîáÉïÉê=jÉãçêó
Multiviewer setups and layouts (including all PIPs, sources and names) can be stored and
recalled using the FSN’s memory system.
Use the following steps to store a Multiviewer layout in a memory register:
1. Set up the Multiviewer in the exact configuration that you want stored.
2. On the Keypad, press STORE. By default, all available modules light in the
keypad’s
Module Section.
3. De-select all modules except for SYS.
4. Enter the desired memory register number.
5. Navigate to the Memory Menu. The selected register will be highlighted in the
table, and the “
STORE” banner will be lit red.
6. Press {Enables} to display the Enables Menu.
7. In the “Enables” box, toggle off all Enables except for Multiviewer.
8. Press {Description} to display the Keyboard.
9. Enter the desired register description and press {Enter}.
10. Press ENTER on the Keypad. The Multiviewer layout is now stored, and
available for recall as desired.
Note
In Store Mode, the description will not appear in the register
table until
ENTER is pressed on the Keypad.