Filter
Top Products
126 FSN Series • User’s Guide • Rev 01
4. Installation
Signal Connections
k~íáîÉ=fåéìí=`çååÉÅíáçåë
The figure below illustrates native input connections on a NIC’s rear panel:
Figure 4-18. Native input connections
Use the following steps to connect native inputs to a NIC. All connections use BNC
cables.
1. Connect SD-SDI or HD-SDI input signals to the NIC’s SDI inputs 1 through 8. All
signals must match the system’s native resolution, as set on the Output Setup
Menu. In Chapter 6, refer to the “Reference Video and Output Setup
” section
on page 287 for instructions on setting the native resolution.
Please note the following important points:
• Use the Input Setup Menu to set up native SDI input signals. In Chapter 5, refer
to the “Input Menu” section on page 202 for menu details.
• In Chapter 6, refer to the “Native Input Setup” section on page 291 for step-by-
step setup instructions.
• If you want to connect an input to the FSN-1400 whose resolution is different that
the system’s native resolution, use a UIC. Refer to the “Universal Input
Connections” section on page 127 for details.
SDI Input 1
SDI Input 2
1
2
3
4
5
6
7
8
SDI
SDI Input 3
SDI Input 4
SDI Input 5
SDI Input 6
SDI Input 7
SDI Input 8
NIC - installs in
slots 1 - 4
Default: 1