Filter
Top Products
FSN Series • User’s Guide • Rev 01 183
5. Menu Orientation
Memory Menu
Please note:
• If a memory register is saved without any NACs or UOCs installed, only Aux 1
through 6 will be saved. If this register is recalled later
with some combination of
NACs and/or UOCs installed, only Aux 1 through 6 will change — the remaining
Aux buses will not change.
• If a memory register is saved with some combination of NACs and/or UOCs
installed, all enabled Aux buses will be saved. If this register is recalled later
without the previous NACs and/or UOCs installed, all installed Aux buses will
change, but the crosspoints for all missing Aux buses will be remembered. If the
missing
NACs and/or UOCs are inserted later in the frame, the outputs will be set
to the crosspoints from this register.
asb=bå~ÄäÉë
The figure below illustrates the available Enables when the DVE module is selected. All
four Enables are present, regardless of the number of DVE channels physically installed.
Figure 5-67. DVE Enables
Following are descriptions of each DVE Enable:
• {DVE Ch 1} through {DVE Ch 4} — stores or recalls the entire effect associated
with the selected DVE channel — as currently programmed on the
DVE Menu.
pÉäÉÅíáåÖ=oÉÖáëíÉêë
The following methods are available for selecting memory registers:
• Control Panel Selection — in both Store and Recall modes, you can select
registers using the
Memory Section’s keypad. If the Memory Menu is visible,
the highlight jumps to the new register.
• Memory Menu, Table Selection — In the Store, Recall and View modes, you
can select a register simply by touching any of the 15 visible rows in the register
table. The highlight jumps to the selected register.
• Memory Menu, Knob Selection — In the Store, Recall and View modes, on
both the
Memory Menu and the Enables Menu, you can select a register by
turning the knob adjacent to the
{Memory Register} value button.
~ Turn clockwise to scroll down the list, incrementing register numbers.
~ Turn counter-clockwise to scroll up, decrementing register numbers.
On the
Memory Menu, note that when the highlight reaches the top or bottom of
the screen, it remains there — and the entire table scrolls.
Note
The Fine Adjust button in the Memory Section affects the
scrolling rate. When
Fine Adjust is Off, turning the knob
scrolls in very large increments. When
On, turning the knob
scrolls in small increments.