Filter
Top Products
248 FSN Series • User’s Guide • Rev 01
5. Menu Orientation
System Menu
~ Press {V Total} or use the adjacent Knob to set the desired total number
of vertical lines in the output image.
• Press {Active and Pos} to set the H and V active area, and the H and V position.
Four value buttons appear:
~ Press {H Pos} or use the adjacent Knob to set the start of the active
area’s horizontal offset from H sync, in pixels.
~ Press {V Pos} or use the adjacent Knob to set the start of the active
area’s vertical offset from V sync, in lines.
~ Press {H Active} or use the adjacent Knob to set the width of the active
area, in pixels.
~ Press {V Active} or use the adjacent Knob to set the number of active
vertical lines in the output.
• Press {Sync} to adjust the horizontal and vertical sync pulse width. Two value
buttons appear:
~ Press {H Sync} or use the adjacent Knob to adjust the horizontal sync
pulse width, in pixels.
~ Press {V Sync} or use the adjacent Knob to adjust the vertical sync
pulse width, in lines.
• Press {Offset Timing} to adjust the UOC output’s video timing relative to the
system’s native resolution. Please note:
~ If the selected UOC output format is vertically locked to the native
resolution’s vertical sync, the
{Offset Timing} button is active.
~ If the selected UOC format is not vertically locked to the native
resolution’s vertical sync, the
{Offset Timing} button is grayed out.
When
{Offset Timing} is pressed, two value buttons appear, along with the
{Offset Timing Info} button:
~ Press {H Offset} or use the adjacent Knob to offset the output’s
horizontal timing (in pixels), relative to the timing of the system’s native
resolution. The adjustment range is +/- 1/2 line.
~ Press {V Offset} or use the adjacent Knob to offset the output’s vertical
horizontal timing (in lines), relative to the timing of the system’s native
resolution. The adjustment range is +/- 1/2 frame.
• Press {Offset Timing Info} to display a pop-up with the following important
information on video output offset timing:
~ If the reference input is set to External, H and V offsets adjust the video
output relative to the video reference input. H and V can be positive or
negative values.
~ If the reference input is set to Free Run, H and V offsets adjust the video
output relative to the switcher’s internal Black signal.
Note that the system’s reference input is set on the
Reference and Output Setup
Menu
. Refer to the “Reference and Output Setup Menu” section on page 197
for details.
Important
Changing the H and V Totals will cause a disruption to the
UOC’s output video. Press
{Apply} to apply changes, or
{Undo} to reverse un-applied changes.
Active
and
Pos
Sync
Offset
Timing
Offset
Timing
Info