Filter
Top Products
328 FSN Series • User’s Guide • Rev 01
7. Operations
Using Re-entry
rëáåÖ=oÉJÉåíêó
The Re-entry buttons on the PGM bank enable you combine the contents of the M/E bank
into the switcher’s output. This holds true for the
PGM, PST and KEY buses:
• When M/E is selected on the PGM bus, the entire output of the M/E bank is on
program. This enables you to cut to the M/E — in the same way that you cut
between cameras and other sources.
• When M/E is selected on the PST bus, the entire output of the M/E bank is
available on preset. This enables you to preset the M/E, and transition to it — in
the same way that you mix, cut and wipe to cameras and other sources.
• When M/E is selected on the KEY bus, the entire output of the M/E bank is
available as a key source. This enables you to create a “look” on the M/E, and
key that look over the PGM source.
• When M/E 2 Control is enabled on the FSN-150, by default, the three M/E
buttons in the
PGM bank remain mapped in the normal manner. However,
additional re-entry buttons for
M/E 1 and M/E 2 are not mapped into the bus rows.
These additional mappings would enable you to re-enter M/E 1 into M/E 2, for
example. To create these additional mappings, use the
Map Buttons Menu.
~ In Chapter 6, refer to the “Button Mapping” section on page 297 for
button mapping instructions.
~ Refer to the “M/E 2 Control on the FSN-150” section on page 349 for
instructions on M/E 2 control.
M/E
Tip
In practice, user’s will preset the M/E, recall a memory
register to the M/E only, and then transition to the new look.
Once complete, you can transition back to a straight source
on PGM, and free the M/E for the next memory register recall.