Filter
Top Products
388 FSN Series • User’s Guide • Rev 01
8. DVE Operations
DVE Menu Orientation
asb=iáåâë
The DVE Links function enables you to link two or more DVE channels together. When
links are on, all linked channels are programmed as one. When links are off, all assigned
DVE channels can be programmed individually.
To link or unlink channels, press
{DVE Links} to display the Link DVE Channels Pop-up,
which enables you to select and link channels, and turn links off. The figure below
illustrates the
DVE Links Pop-up:
Figure 8-18. DVE Links Pop-up (sample)
The Link DVE Channels Pop-up provides buttons for all DVE channels, whether or not
they are installed. Each channel’s current name appears on the button label.
• To enable DVE links, turn on the desired channel buttons, then press {Close} to
close the pop-up. The inset on the
{DVE Links} button changes to “On.”
• To cancels all links, press {All Links Off}, then close the pop-up. The inset on the
{DVE Links} button changes to “Off.”
Please note the following important points regarding links:
• Links have no effect on the behavior of the Cut or Auto Trans buttons on the
control panel. However, if you have two or more channels linked, each channel
must be “armed” to trigger, in the normal manner.
• Links affect the DVE channels, but not the keyers or the keyframes.
• Once DVE channels are linked, the two “run” buttons on the DVE Menu run all
linked channels (provided the channels contain two keyframes).
• Links are not saved in memory registers or during a backup/restore process.
DVE
Links
Off
DVE-2
Link DVE Channels Close
All
Links
Off
Current DVE Links
1234
DVE-1 DVE-3 DVE-4