Filter
Top Products
FSN Series • User’s Guide • Rev 01 111
4. Installation
FSN-1400 Rack-Mount Procedure
3. To facilitate easy rack mounting, each rack ear on the front of the FSN-1400 is
equipped with a special “keyhole” slot on the lower hole, as shown below.
Figure 4-7. Rack Ear Keyhole
To take advantage of this feature, ensure that there is at least 1/2” of clearance
above the chassis’ intended 6RU location.
Figure 4-8. Equipment Rack Layout
4. For the FSN-1400’s two keyhole slots, measure and install two rack screws in
your equipment rack’s front rails. Allow each screw to protrude approximately 3/4”
from the surface of the rails.
5. Lift the chassis, and while supporting it, slide the side rails through the slots in the
rear mounting brackets.
6. While continuing to support the chassis, slide the screws (in the front rails)
through the two keyholes, and let the chassis settle up into the keyhole slots.
7. Tighten the two lower screws, then install and tighten the two uppers screws in the
rack rail.
6RU
.5" Additional
Clearance