Filter
Top Products
FSN Series • User’s Guide • Rev 01 305
6. System Setup
Saving the Setup
p~îáåÖ=íÜÉ=pÉíìé
FSN Series system setup: Step 17
This procedure enables you to save all system setup parameters to non-volatile memory.
S Prerequisite — Ensure that you are familiar with the Save All function. In
Chapter 5, refer to the “
Save All” section on page 272.
Use the following steps to save all system setup parameters:
1. In the Menu Bar, press {System} to access the System Menu.
2. Press {Save All} to display the confirmation pop-up.
3. Press {Close} to clear the pop-up.
_~ÅâáåÖ=ìé=íÜÉ=póëíÉã
FSN Series system setup: Step 18
In this procedure, you will back up your system configuration to a USB drive.
S Prerequisite — Ensure that you are familiar with the Backup and Restore
Menu. In Chapter 5, refer to the “Backup and Restore Menu” section on
page 273.
Use the following steps to back up your system to a USB Drive:
1. Ensure that your USB drive is properly inserted in the control panel’s USB Port.
2. In the Menu Bar, press {System} to access the System Menu.
3. Press {Backup and Restore} to display the Backup and Restore Menu.
4. Press {Backup System} to display the Backup Menu.
5. If required, create a new folder or rename a folder.
6. Press {Backup System} to initiate the system backup procedure. Once the drive
is detected, you will be prompted to continue or cancel the procedure. At the
conclusion of this procedure, your system is completely backed up.
17
18