Filter
Top Products
FSN Series • User’s Guide • Rev 01 217
5. Menu Orientation
System Menu
~ Select RGB to process the input signal in RGB color space (4:4:4), in
which the individual red, green and blue signals are sampled at the same
rate. The
RGB mode is typically used for computer and graphic sources.
• Press {1:1 Sample} to toggle the 1:1 sampling mode on or off.
~ Select On to process the input with pixel-for-pixel sampling to provide
better image quality.
~ Select Off to process the input with multiple samples for every pixel.
This mode generally results in a “softer” image.
• Press {Sample Phase} to display the Sample Phase value button. Use the
button (or knob) to adjust the input’s A/D converter, allowing you to select where
pixels are sampled (ideally, on the pixel’s peak).
Range: -16 to 15
Default: 0
For optimum visual results when adjusting high-resolution sources, output a burst
test pattern from the source, and adjust for minimum noise.
• Press {Adjust H Timing} to adjust the image’s horizontal timing. Three value
buttons appear:
~ Use the {H Pos} button (or knob) to set the start of the active area’s
horizontal offset from H sync.
~ Use the {H Active} button (or knob) to set the width of the active area.
~ Use the {H Total} button (or knob) to set the total pixel count per line.
• Press {Adjust V Timing} to adjust the image’s vertical timing. Two value buttons
appear:
~ Use the {V Pos} button (or knob) to set the start of the active area’s
vertical offset from V sync.
~ Use the {V Active} button (or knob) to set the number of vertical lines in
the image.
Note
This function is available for DVI and analog inputs only, with
the exception of NTSC and PAL. The button does not appear
when an SDI, NTSC or PAL input is selected on the
UIC.
1:1
Sample
On
Note
This function is available for analog inputs only, with the
exception of NTSC and PAL. The button does not appear
when SDI, DVI, NTSC or PAL inputs are selected on the
UIC.
Sample
Phase
Note
This function is available for analog inputs only, with the
exception of NTSC and PAL. The button does not appear
when SDI, DVI, NTSC or PAL inputs are selected on the
UIC.
Adjust
H
Timing
Note
This function is available for analog inputs only, with the
exception of NTSC and PAL. The button does not appear
when SDI, DVI, NTSC or PAL inputs are selected on the
UIC.
Adjust
V
Timing