Filter
Top Products
330 FSN Series • User’s Guide • Rev 01
7. Operations
Setting Transition Rates and Curves
pÉííáåÖ=qê~åëáíáçå=o~íÉë=~åÇ=`ìêîÉë
The Transition Menu enables you to change auto transition rates and transition curves.
S Prerequisite — Ensure that you are familiar with the Transition Menu. In
Chapter 5, refer to the “
Transition Menu” section on page 148.
Use the following steps to set transition rates and curves:
1. Navigate to the Transition Menu, either by pressing and holding any MIX button,
or by using the
Menu Bar.
2. To adjust transition rates with the knobs:
~ Turn the knob adjacent to the M/E 1 or M/E 2 button to adjust the rate.
~ Turn the knob adjacent to the PGM button to adjust the PGM rate.
~ Turn the knob adjacent to the FTB button to adjust the FTB rate.
3. To adjust transition rates with the Keypad:
~ Press the M/E 1 or M/E 2 button to display the Keypad. Enter or trim the
transition rate for the M/E, then press
{Enter} to accept.
~ Press the PGM button to display the Keypad. Enter or trim the transition
rate for the PGM bank, then press
{Enter} to accept.
~ Press the FTB button to display the Keypad. Enter or trim the transition
rate for the FTB, then press
{Enter} to accept.
4. To adjust all transition rates simultaneously, press {All/Set Trim}.
~ To “set” a new rate, press any value button to display the Keypad.
• To set all rates to the value in the register, press
{Enter}.
• To set all rates to a value, enter the value and press
{Enter}.
~ To trim all rates simultaneously as offsets to their current values:
• Turn any
Knob to increment or decrement all rates.
• Press any value button to display the
Keypad. Enter the
desired “trim” value and press
{Trim +} or {Trim -} as desired.
5. Transition curves are applied when you press AUTO TRAN in a selected bank, or
the
FTB button. To select transition curves:
~ For M/E 1 or M/E 2, press the {Linear}, {S Curve}, {Exponential}, or
{Logarithmic} button in the row adjacent to the desired button.
~ For the PGM bank curve, press the {Linear}, {S Curve}, {Exponential},
or
{Logarithmic} button in the row adjacent to the PGM button.
~ For the FTB curve, press the {Linear}, {S Curve}, {Exponential}, or
{Logarithmic} button in the row adjacent to the FTB button.
MIX
Note
The M/E 1 transition rate applies to the buttons in the Direct
Key Control Group
(MIX KEY 1 and MIX KEY 2).
Note
Transition curves also apply to the buttons in the Direct Key
Control Group
(MIX KEY 1 and MIX KEY 2).