Filter
Top Products
FSN Series • User’s Guide • Rev 01 199
5. Menu Orientation
System Menu
• Press {Ref Output} to change the reference video signal that is currently
available on the
REF OUT connector. Two options are available:
~ Tri-level — selects a tri-level signal as the reference output.
~ Burst — selects a black burst signal as the reference output.
As shown in the following table, note that the
{Ref Output} button is grayed out
when certain output formats are selected, and a default signal is automatically
provided on the
REF OUT connector.
• Press {Ref Output Timing} to set the H and V offsets of the selected reference
output. Two value buttons appear:
~ Press {Ref H Offset} or use the adjacent Knob to set the desired
amount of horizontal offset (in pixels).
~ Press {Ref V Offset} or use the adjacent Knob to set the desired
amount of vertical offset (in lines).
• Press the {Ref Info} button to display a pop-up with important information
regarding the ability to change the reference output offsets.
Figure 5-78. Reference Output Information Pop-up
Ref
Output
Burst
Table 5-4. Reference output format exceptions
Output Format Format Automatically Selected on REF OUT
NTSC (480i) Black Burst
PAL (576i) Black Burst
1080p @ 23.98 Tri-level
1080p @ 24 Tri-level
Ref
Output
Timing
Ref
Info
Reference Video and TimingNote
Please note the following important information:
If the reference input is set to External, H and V offsets
adjust the video reference output relative to the video
reference input. H and V can be positive or negative values.
If the reference input is set to Free Run, H and V offsets
adjust the video reference output relative to the switcher’s
internal Black signal.
Close