Filter
Top Products
FSN Series • User’s Guide • Rev 01 287
6. System Setup
Reference Video and Output Setup
oÉÑÉêÉåÅÉ=sáÇÉç=~åÇ=lìíéìí=pÉíìé
FSN Series system setup: Step 6
In this procedure, you will set up the system’s video reference input, output format (native
resolution), and the output V-Lock setting.
S Prerequisite — Ensure that you are familiar with the Reference and Output
Setup Menu. In Chapter 5, refer to the “Reference and Output Setup
Menu” section on page 197.
Set up reference — Use the following steps to set up video reference input:
1. In the Menu Bar, press {System} to access the System Menu.
2. Press {Ref and Output Setup} to display the Reference and Output Setup
Menu
.
3. Press {Reference Input} to display two reference options:
~ Press {Free Run} to select the FSN-1400’s internal sync generator as
the reference.
~ Press {External} to select the REF IN connector on the System Card.
One of three external signals can be connected:
• SMPTE bi-level sync
• Tri-level sync
• Black burst
Set up format — Use the following steps to set up the output format:
1. On the Reference and Output Setup Menu, press {Output Format} to display
the
Output Format Keypad.
2. Select the desired format and press {Apply}. In the confirmation pop-up, click
{Set Output Format} to confirm.
6
Note
If External is selected, ensure that the proper signal is
connected to the
REF IN connector on the System Card. In
Appendix A, refer to the “
Reference Video Input
Specifications” section on page 433 for detailed information
about the allowed frame rates for the reference input.
Important
Remember that all input settings will be reset to their default
values when you change output formats.