Filter
Top Products
FSN Series • User’s Guide • Rev 01 259
5. Menu Orientation
System Menu
• Press {Joystick} to toggle the Joystick on and off. When you toggle the
Joystick off, a pop-up asks you to confirm the procedure. When off, the Joystick
no longer functions, and the
{Re-center} button is grayed out.
• Ensure that the Joystick is fully at rest, then press {Re-center} to re-center the X,
Y and Z axes. Use this function only if the Joystick does not display 0% on all
axes when fully at rest.
• Press {T-Bar M/E} to toggle the M/E’s T-Bar on and off. When you toggle it off, a
pop-up asks you to confirm the procedure. When off, the
T-Bar no longer
functions on the control panel, and the
{Set Top Limit} and {Set Bottom Limit}
buttons are grayed out.
• A {Set Top Limit} button is provided for each T-Bar on the switcher. Move the
selected
T-Bar to its top limit, then press {Set Top Limit} to calibrate the T-Bar’s
top position. In the pop-up, press
{Calibrate}.
• A {Set Bottom Limit} button is provided for each T-Bar on the switcher. Move
the selected
T-Bar to its bottom limit, then press {Set Bottom Limit} to calibrate
the T-Bar’s bottom position. In the pop-up, press
{Calibrate}.
`~äáÄê~íÉ=qçìÅÜ=pÅêÉÉå
From the Diagnostics Menu, press {Calibrate Touch Screen} to run the Touch Screen’s
interactive calibration routine. A special calibration screen appears, on which you will be
asked to touch certain areas, and then accept the new calibration. After you accept the
calibration, the system will return to the FSN Series menus.
Joystick
On
Note
It is recommended that you leave the Joystick on.
Re-
center
T-Bar
M/E
On
Note
It is recommended that you leave the T-Bar on.
Note
The {T-Bar PGM} button performs the identical function for
the PGM bank’s
T-Bar.
Set Top
Limit
Set
Bottom
Limit
Calibrate
Touch
Screen
Tip
For a more accurate calibration, use a pencil eraser instead
of your finger tip.
Important
As an alternate method, if required, you can start the Touch
Screen
calibration procedure by simultaneously pressing the
FINE ADJUST and ENTER buttons on the Keypad.