Filter
Top Products
182 FSN Series • User’s Guide • Rev 01
5. Menu Orientation
Memory Menu
póëíÉã=bå~ÄäÉë
The figure below illustrates the Enables when the SYS (System) module is selected:
Figure 5-65. SYS Enables
Following are descriptions of each System Enable:
• {Input Map} — stores or recalls the panel’s current input mapping, as set on the
Map Buttons Menu. Refer to the “Map Buttons Menu” section for details.
• {All Inputs} — stores or recalls all input setup parameters (including the name)
for both native and universal inputs, as set on the
Input Setup Menu. Refer to
the “
Input Menu” section on page 202 for a menu description.
• {Tally} — stores or recalls all tally settings, as set on the Tally Setup Menu.
Refer to the “
Tally Setup Menu” section on page 235 for a menu description.
• {Aux Setup} — stores or recalls all Aux bus settings, as configured on the Aux
Setup Menu. This Enable does not store Aux routes. Refer to the “Aux Setup
Menu” section on page 240 for additional details.
• {DVE Assign} — stores or recalls all DVE assignments, as set on the DVE
Assign Menu
. Refer to Chapter 8, “DVE Operations” for details.
• {Multi Viewer} — stores or recalls all multiviewer settings, as set on the
Multiviewer Setup Menu. Refer to the “Multiviewer Setup Menu” section on
page 239 for menu details.
^ìñ=bå~ÄäÉë
The figure below illustrates the available Enables when the Aux module is selected. Note
that if optional
NACs and UOCs are installed, different combinations of additional Aux
buses will be enabled. If an Enable is grayed out, the Aux card is either not installed, or the
Aux output has been re-mapped using the
Aux Setup Menu.
Figure 5-66. Aux Enables (sample)
Following are descriptions of each Aux Enable:
• {Aux 1} through {Aux 30} — stores or recalls the source assignment on the
selected Aux Bus. For example, if
CAM 1 is assigned to Aux 2, that association
will be stored or recalled in the memory register.