Filter
Top Products
250 FSN Series • User’s Guide • Rev 01
5. Menu Orientation
System Menu
• Black bars are visible above and below an image, for example,
when a 16:9 image is scaled down to 4:3.
• The top and bottom portions of an image may fall outside of the
raster, for example, when a 4:3 image is scaled up to 16:9.
~ Press {Fill V} to scale the output up (or down) to the selected vertical
resolution. Please note:
• Aspect ratio is maintained. Manual size/position adjustments
using the four value buttons are maintained.
• If the top and/or bottom edges of the image are manually
masked, those edges are used for the
Fill V calculations.
• Black pillars are visible to the left and right of an image, for
example, when a 4:3 image is scaled up to 16:9.
• The left and right portions of an image may fall outside of the
raster, for example, when a 16:9 image is scaled down to 4:3.
~ Press {Fill H/V} to scale the output up (or down) to the selected
horizontal and vertical resolutions. Please note:
• Aspect ratio is not maintained. Non-proportional image
stretching or compression will occur.
• If any edges of the image are manually masked, those edges
are used for the
Fill H/V calculations.
~ Use the {Reset} function to reset all size and position values to default.
When
{Size and Position} is selected, one additional function is available in the
Tool Bar:
~ Press {Aspect Ratio} to display the Aspect Ratio Pop-up. This
function affects the output’s H dimension only. Choices are 16:9, 5:4,
4:3, 3:2, 1:1 and Custom.
When
{Custom} is selected, the {Adjust Custom Aspect} button
appears in the
Tool Bar. Press to display the {Custom Aspect} value
button. Unlatch to re-display size and position adjustments.
• In the Output Sizing and Scaling section, press {Pan Zoom Source} to display
four buttons which enable you to size and position the video
within the boundaries
of the output’s current sizing. In this mode, the output’s outside boundaries
remain constant, but you can pan and zoom the video inside, as desired.
The following functions are provided:
~ Press {Source H Size} or use the knob to change horizontal size inside
the output’s boundaries. Remember that
{Source H Size} and {Source
V Size}
track together if the {Lock} is enabled.
~ Press {Source V Size} or use the knob to change vertical size inside the
output’s boundaries.
~ Press the {Lock} button to lock or unlock H and V source size tracking.
When locked, both parameters track together. When unlocked,
H and V
can be adjusted independently.
~ Press {Source H Pos} or use the knob to change the horizontal position
inside the output’s boundaries along the X axis.
Aspect
Ratio
16:9
Pan
Zoom
Source
Note
The Pan Zoom Source function does not allow you to reveal
video that is outside of the output’s active area.