Filter
Top Products
FSN Series • User’s Guide • Rev 01 309
7. Operations
Quick Setup and Operations
16. Save system configuration — After completing all “system” setups, save the
configuration and back up the system.
~ Chapter 6, “Saving the Setup,” page 305.
~ Chapter 6, “Backing up the System,” page 305.
17. Set up Aux buses — As required, map all aux buses, and set up all Aux bus
routes to peripheral destinations. (“
Working with Aux Buses,” page 346.)
18. Set up Multiviewer
— As required, set up the Multiviewer and assign sources to
Multiviewer PIPs. (“
Multiviewer Operations,” page 411.)
19. Set up transition rates
— As required, set up all transition rates for all banks and
FTB. (“
Setting Transition Rates and Curves,” page 330.)
20. Set up wipes — Select the desired wipe patterns, and adjust direction and border
type. (“
Working with Wipes,” page 332.)
21. Set up keys — Select the desired key sources, and adjust type, fill, clip, gain and
opacity as required. (“
Working with Keys,” page 333.)
22. Set up and program DVE effects — If the optional DVE card(s) are installed,
assign DVE channels to keyers and program the desired DVE effects.
(Chapter 8, “
DVE Operations,” page 353.)
23. Set up memory registers — Set up the desired “looks” for your show, and store
them in memory registers as required. (“
Working with Memory Registers,”
page 337.)
24. Ready to roll — With all output, input and system configurations saved, and all of
your important “looks” stored in memory, put on your headsets and get busy!
Note
For detailed system operating procedures, specific system
“tweaks” and operating descriptions on every feature, please
start with the “
Quick Function Reference” section on
page 310, and select the function that you wish to perform.