Filter
Top Products
340 FSN Series • User’s Guide • Rev 01
7. Operations
Working with Memory Registers
píçêÉI=_óé~ëë=bå~ÄäÉëI=båíÉê=`ìëíçã=k~ãÉ
Use the following steps to store a memory register, bypass the Enables menu, and
enter a custom register description:
1. Set up the switcher in the exact configuration that you want stored.
2. On the Keypad, press STORE. By default, all available modules light in the
keypad’s
Module Section.
3. Select the desired modules to include (or exclude) in the register. If you don’t take
any action, all modules remain enabled.
4. Enter the desired register number.
5. Navigate to the Memory Menu. The selected register will be highlighted in the
table, and the “
STORE” banner will be lit red.
6. Press {Description} to display the Pop-up Keyboard.
7. Enter the desired description and press {Enter}.
8. Press ENTER on the Keypad. The register is stored with all Enables are on,
along with the custom description. Above the
Keypad, the selected register
number and the custom description appear in the
Memory Display, adjacent to
the prefix “
STR:”
píçêÉI=pÉí=bå~ÄäÉëI=båíÉê=`ìëíçã=k~ãÉ
Use the following steps to store a memory register, set Enables, and enter a custom
register description:
1. Set up the switcher in the exact configuration that you want stored.
2. On the Keypad, press STORE. By default, all available modules light in the
keypad’s
Module Section.
3. Select the desired modules to include (or exclude) in the register. If you don’t take
any action, all modules remain enabled.
4. Enter the desired register number.
5. Navigate to the Memory Menu. The selected register will be highlighted in the
table, and the “
STORE” banner will be lit red.
6. Press {Enables} to display the Enables Menu.
7. On the modules row, press the light blue button for the first module in which you
want to set Enables.
8. In the “Enables” box, toggle the desired Enables on or off, as required. By default,
they are all on, when you first store a register. Remember that you can also use
the
{All On} and {All Off} functions.
9. Repeat steps 7 and 8 for all remaining modules in which you want to set Enables.
10. Press {Description} to display the Keyboard.
Note
In Store Mode, the description will not appear in the register
table until
ENTER is pressed on the Keypad.