Filter
Top Products
FSN Series • User’s Guide • Rev 01 201
5. Menu Orientation
System Menu
~ Off — In this mode, you can not set H and V offsets, and the {Sync
Mode} button is active on the Input Setup Menu.
• When {Output V-Lock} is On, press {SDI Output Timing} to set SDI H and V
offsets, anywhere relative to video reference. Two value buttons appear:
~ Press {SDI H Offset} or use the adjacent Knob to set the desired
amount of horizontal offset (in pixels) from video reference.
~ Press {SDI V Offset} or use the adjacent Knob to set the desired
amount of vertical offset (in lines) from video reference.
• Press the {Output V-Lock Info} button to display a pop-up with important
information regarding the
Output V-Lock mode. This button only appears when
the
{Reference Input} button is set to External.
Figure 5-80. Output V-Lock Information Pop-up
Important
When {Output V-Lock} is On, the position of the DSK Cut
and
DSK Fill inputs on screen will change.
• If the user preference “Black on Invalid Video” is
turned on, the DSK turns off — because of the change
in output timing.
• If the user preference “Black on Invalid Video” is off,
the DSK will be visible — but in a shifted position. In
this condition, the video position can be adjusted by
changing the output timing of the DSK source itself.
Note
When {Output V-Lock} is turned Off, after having been On,
all inputs return to
Auto Mode on the Input Setup Menu.
Important
When {Output V-Lock} is Off, the least amount of video
delay is provided through the switcher. The
DSK Cut and
DSK Fill inputs must be within ± 0.5 line of video reference.
SDI
Output
Timing
Output
V-Lock
Info
Output V-Lock InformationNote
Please note the following important information:
When Output V-Lock is on, H and V offsets can be set
anywhere relative to the external video reference input. All
native inputs are forced to Frame Sync mode, and one
frame of delay will be incurred on all native inputs. On the
Input Setup Menu, the Sync Mode button is grayed out.
When Output V-Lock is off, you can not set H and V
offsets. On the Input Setup Menu, the Sync Mode button
is active.
Close