Filter
Top Products
FSN Series • User’s Guide • Rev 01 233
5. Menu Orientation
System Menu
Three mutually exclusive clean feed points are provided for M/E 2’s clean feed output:
• Press {M/E 2 Clean 1} to select the clean feed point prior to Keyer 1.
• Press {M/E 2 Clean 2} to select the clean feed point prior to Keyer 2.
• Press {M/E 2 Out} to select the M/E 2 program output.
Two mutually exclusive points are provided for the PGM bank’s clean feed output.
• Press {PGM Clean} to select the clean feed point prior to the DSK.
• Press {PGM Out} to select the program output (after the DSK).
^ëëáÖå=_ìííçå
Press {Assign Button} to select the clean feed source that is mapped to the ASSIGN
button in the control panel’s
Aux Section. This feature enables you to place a clean feed
source on the
Aux Source Row, and select it (just as you would any other available
source), and send it to an Aux bus destination.
When
{Assign Button} is pressed, the Palette changes to display a different “flow-chart.”
This diagram represents the clean feed points that can be mapped to the
ASSIGN button,
with buttons provided for each selection point.
Figure 5-106. Clean Feed Setup Menu, Assign Button selection (sample)
One of three mutually exclusive clean feed points can be mapped to the ASSIGN button:
• Press {M/E 1 Clean 1} to select the clean feed point prior to M/E 1, Keyer 1.
• Press {M/E 1 Clean 2} to select the clean feed point prior to M/E 1, Keyer 2.
Assign
Button