Filter
Top Products
FSN Series • User’s Guide • Rev 01 283
6. System Setup
Return to Factory Default
oÉíìêå=íç=c~Åíçêó=aÉÑ~ìäí
FSN Series system setup: Step 2.
Prior to performing any setup procedures, it is recommended that you perform a factory
reset — in order to reset all input, output and source mappings to their default values.
Particularly for customers in the events and rental marketplace, this procedure guarantees
that any previous input setups and memory registers (e.g., those that may have been
programmed by other users) are completely cleared from system memory.
S Prerequisite — Ensure that you are familiar with the Reset Menu. In
Chapter 5, refer to the “
Reset Menu” section on page 274.
Use the following steps to return the system to factory default values:
1. In the Menu Bar, press {System} to access the System Menu.
2. Press {Reset} to display the Reset Menu.
3. Press {Factory Reset} to reset the entire system to its factory default values.
Remember that all data will be lost.
4. When the Reset Confirmation Pop-up appears, you can choose to {Reset and
Save IP
}, or {Reset All}.
2
Note
If you are continuing an event (for example, day two of a
three-day event), you do not need to perform a factory reset.
However, if you do elect to perform a factory reset, ensure
that you have backed up your system. Refer to the “
Backing
up the System” section on page 305 for details.
Note
In Chapter 5, refer to the “Factory Default Settings” section
on page 275 for a list of factory default settings.