Filter
Top Products
FSN Series • User’s Guide • Rev 01 389
8. DVE Operations
Assigning DVE Channels to Keyers
• When a shot box keyframe is recalled, the keyframe settings are recalled into all
linked DVE channels.
• When saving to a shot box register from a linked DVE channel, the keyframe
settings from the currently selected channel (not all linked channels) will be saved
into the shot box register.
• If you delete a Keyframe that’s included in a link, the active keyframes of all linked
channels will be deleted.
• When links are enabled, the {Border Shadow Opacity} button is grayed out.
^ëëáÖåáåÖ=asb=`Ü~ååÉäë=íç=hÉóÉêë
The DVE Assign Menu enables you to assign available DVE channels to specific keyers
on the control panel.
S Prerequisite — Ensure that you are familiar with the DVE Assign Menu.
Refer to the “
DVE Assign Menu” section on page 363 for details.
Use the following steps to assign DVE channels to keyers:
1. Navigate to the DVE Assign Menu by pressing {System} in the Menu Bar, then
{DVE Assign}.
2. On the DVE Assign Menu, name your available DVE channels, if desired:
a. Press {Name Channel} to enter the naming mode.
b. Press the desired channel button in the Rear I/O View.
c. When the keyboard appears, enter the desired name and press
{ENTER}.
d. When finished, press {Name Channel} to exit the mode.
3. To assign DVE channels to keyers:
a. Press the desired keyer button in the DVE Assignment Table.
b. Press the DVE channel that you want to dedicate to that Keyer.
c. Repeat from step “3a” for all remaining assignments.
4. Store your DVE assignments using the SYS category in the memory system. A
specific “enable” button
{DVE Assign} is provided on the Enables Menu. In
Chapter 5, refer to the “
System Enables” section for details.
Note
Remember that based on your DVE assignments, you can fly
PIPs, luma keys, linear keys and split keys. On the
DVE
Assign Menu
, press {DVE Assign Info} to display the DVE
Assignment Information Pop-up
for detailed information.