Filter
Top Products
FSN Series • User’s Guide • Rev 01 295
6. System Setup
Universal Input Setup
2. Use the {Mask Top}, {Mask Bottom}, {Mask Left} and {Mask Right} controls to
mask selected portions of the image, as required.
3. Select the method by which you want to size and scale the image. Masked edges
are taken into account.
~ Press {Fill H} to scale the selected universal input up (or down) to the
current native
horizontal resolution. Aspect ratio is maintained.
~ Press {Fill V} to scale the input up (or down) to the current native
vertical resolution. Aspect ratio is maintained.
~ Press {Fill H/V} to scale the input up (or down) to the current native
horizontal and vertical resolutions. Aspect ratio is not maintained.
4. If required, press {Reset Fill} to return the input to its previous scaling. Mask
settings are retained.
5. If required, press {Clear Mask} to return all mask settings to 0 (zero). Scaling is
maintained.
6. Press {Reset All} to return the input to its previous scaling, and return all mask
settings to 0 (zero).
Color Correction — Use the following steps to set up universal input color correction:
1. To adjust the selected input’s overall brightness and contrast, press {Bright
Contrast}. Use the {Bright} and {Contrast} controls as desired.
2. To adjust the input’s RGB brightness, press {RGB Bright}. Use the {Red Bright},
{Green Bright} and {Blue Bright} controls as desired.
3. To adjust the input’s RGB contrast, press {RGB Contrast}. Use the {Red
Contrast}, {Green Contrast} and {Blue Contrast} controls as desired.
4. To adjust hue and color saturation, press {Hue Sat}. Use the {Hue} and {Sat}
controls as desired.
Save Input Settings — Use the following steps to save input settings:
1. Press {Save Settings} to save the selected input’s setup parameters.
2. Press {Back} to return to the Input Menu.
3. Repeat from step 3 for each additional input that you wish to set up.
Important
Because you can install either a NIC or a UIC in slots 3 and 4,
If you move or change card assignments in these two slots
during setup, the setup is invalidated, and must be repeated
once the final card configuration is reached.