Filter
Top Products
342 FSN Series • User’s Guide • Rev 01
7. Operations
Working with Memory Registers
oÉÅ~ääáåÖ=jÉãçêó=oÉÖáëíÉêë
When you recall a memory register, you are recalling all (or part) of the stored register’s
contents back to the switcher.
Recalling a memory register and bypassing the Enables is an easy equation. This method
recalls the entire contents of the selected module(s).
• RECALL, [select register #], ENTER
Recalling a memory register and adjusting Enables is also an easy equation. This method
recalls partial contents of the selected module(s).
• RECALL, [select modules], [adjust Enables], ENTER
The following topics are discussed in this section:
• Recall, Bypass Enables
• Recall, Adjust Enables
• Memory Recall Notes
oÉÅ~ääI=_óé~ëë=bå~ÄäÉë
Use the following steps to recall a memory register and bypass Enables:
1. On the Keypad, press RECALL.
2. Enter the desired register number. Note that the module buttons will light for the
exact modules contained in the register.
3. Press ENTER. The entire memory register is now recalled to the panel.
Please note:
~ Above the Keypad, the selected register number and the register
description appear in the
Memory Display, adjacent to the prefix “RCL:”
~ If the register was recalled to an M/E, the PGM bank or both, the
selected register number appears in the respective
Transition Display,
below the label “
MEM.”
oÉÅ~ääI=^Çàìëí=bå~ÄäÉë
Use the following steps to recall a memory register and adjust the Enables:
1. On the Keypad, press RECALL.
2. Enter the desired register number. Note that the module buttons will light for the
exact modules contained in the register.
3. Navigate to the Memory Menu. The selected register will be highlighted in the
table, and the “
RECALL” banner will be lit red.
4. Press {Enables} to display the Enables Menu.
5. On the modules row, press the light blue button for the first module in which you
want to adjust Enables.
~ Note that only the “stored” modules will be blue. All other modules will
be grayed out.
~ In the “Enables” box, note that the enables will appear exactly as stored.
All those that were not enabled will be grayed out.
6. Toggle the desired Enables on or off, as required. Remember that you can also
use the
{All On} and {All Off} functions.