Filter
Top Products
FSN Series • User’s Guide • Rev 01 97
3. Control Panel Orientation
Control Panel Descriptions
parallel with the Touch Screen’s keypad — either one can be used for
entry, depending on your preference.
Following are descriptions of each Keypad button:
~ The AUTO TRAN button is not available in version 3.0.
~ Press BACKSPACE (←) during a numeric entry process to clear the
register by one digit with each press.
~ Press FINE ADJUST to change the sensitivity of the knobs and the
Joystick.
• When off, adjustment is coarse.
• When on, adjustment is fine.
~ Press CLEAR during a numeric entry process to clear the entire register.
A dash (–) appears in the register, but the selected mode (store or recall)
and all selected modules remain lit.
Press and hold CLEAR to cancel the current store or recall function
completely. The STORE or RECALL button automatically turns off.
~ Enter an offset value using the numeric buttons, then press TRIM - to
subtract from the parameter’s current value. For example, if a
parameter’s value is 100, press 10, TRIM -, to calculate 90. Pressing
ENTER is not required, and the “trim” value remains in the register,
enabling you to trim repeatedly by the same offset.
In Chapter 5, see the “Using the Keypad
” section for details.
~ Enter an offset using the numeric buttons, then press TRIM + to add to
the parameter’s value. For example, starting with 100, press 10, TRIM +,
to calculate 110. Pressing ENTER is not required. The “trim” remains in
the register, enabling you to trim repeatedly by the same offset.
In Chapter 5, see the “Using the Keypad
” section for details.
~ Press the numeric buttons 0 through 9 to enter numbers for memory
registers and other functions in the normal manner. Numbers shift left in
the register as you enter them.
~ Press +/- to invert the numeric entry in the register. For example, to
change the entry from + 350 to - 350, press +/-.
AUTO
TRAN
FINE
ADJUST
CLEAR
TRIM -
Note
The TRIM - function is only applicable when a Touch Screen
Keypad is active. It does not apply to memory registers.
TRIM +
Note
The TRIM + function is only applicable when a Touch Screen
Keypad is active. It does not apply to memory registers.
1
+ / -
Note
The +/- button is only applicable when certain Touch Screen
Keypad functions that accept negative values are active.
The +/- button does not apply to memory registers.