Filter
Top Products
FSN Series • User’s Guide • Rev 01 335
7. Operations
Working with Keys
j~åì~ä=jáñ=hÉó
Use the following steps to perform a manual mix key:
1. Ensure that the key(s) you wish to transition are properly set up. Refer to the
“
Key Setup” section for details.
2. In the Next Transition Group, select the layers that you wish to transition:
~ On the M/E, enable KEY 1 and/or KEY 2 as desired. If you want the
background to transition along with the selected key, enable
BG.
~ On the PGM bank, enable DSK. If you want the background to transition
along with the DSK, enable
BG.
3. Use the T-Bar to perform the manual mix key. The selected key(s) will transition
up or down, depending on their current state.
^ìíçã~íáÅ=jáñ=hÉó
Use the following steps to perform an automatic mix key:
1. Ensure that the key(s) you wish to transition are properly set up. Refer to the
“
Key Setup” section for details.
2. In the Next Transition Group, select the layers that you wish to transition:
~ On the M/E, enable KEY 1 and/or KEY 2 as desired. If you want the
background to transition along with the selected key, enable
BG.
~ On the PGM bank, enable DSK. If you want the background to transition
along with the DSK, enable
BG.
3. Press AUTO TRAN.
Please note the following important points regarding automatic mix keys:
• You can also press ALL TRAN (in the Custom Control Section) to perform the
transition on all buses simultaneously.
• Remember that there are a wide variety of auto-transition combinations available.
Refer to the “
Automatic Transitions” section on page 325 for details.
j~åì~ä=táéÉ=hÉó
Use the following steps to perform a manual wipe key:
1. Ensure that the key(s) you wish to transition are properly set up. Refer to the
“
Key Setup” section for details.
2. In the Next Transition Group, select the layers that you wish to transition:
~ On the M/E, enable KEY 1 and/or KEY 2 as desired. If you want the
background to transition along with the selected key, enable
BG.
~ On the PGM bank, enable DSK. If you want the background to transition
along with the DSK, enable
BG.
3. On the Wipe Menu, select the desired pattern, direction, edge type, edge width,
and edge color (if a
Hard Edge wipe is selected).
4. Use the T-Bar to perform the manual wipe key. The selected key(s) will transition
up or down, depending on their current state.