Filter
Top Products
326 FSN Series • User’s Guide • Rev 01
7. Operations
Understanding the T-Bar and Transition LEDs
• Automatic transitions can be paused:
~ Press AUTO TRAN to start the transition.
~ Press AUTO TRAN again, during the interval, to pause the transition.
Note that the
Transition LEDS are paused in between the limits.
~ Press AUTO TRAN to resume the transition.
~ You can pause and resume repeatedly.
• Transitions can be started automatically, paused, and finished manually.
~ Press AUTO TRAN to start the transition.
~ Press AUTO TRAN again, during the interval, to pause the transition.
~ Move the T-Bar to continue the transition manually.
• Transitions can be started automatically, and over-ridden manually.
~ Press AUTO TRAN to start the transition.
~ During the interval, move the T-Bar in the same direction as the
Transition LEDs are moving, to continue the transition manually.
• Transitions can be started manually, and finished automatically.
~ Move the T-Bar to perform a manual transition.
~ Stop the T-Bar at any point before the end-limit.
~ Press AUTO TRAN to complete the transition automatically.
mÜóëáÅ~ä=~åÇ=sáêíì~ä=qJ_~ê=mçëáíáçå
The Transition LEDs next to the T-Bar reflect the state of the transition, not the position of
the physical
T-Bar. Often they will be the same — but sometimes, the physical T-Bar
position and the “virtual”
T-Bar position may not match.
To learn about physical and virtual
T-Bar positions, please practice the following examples.
bñ~ãéäÉ=NW==kçêã~ä=qJ_~ê=ãçîÉãÉåí
Use the following steps to demonstrate physical vs. virtual T-Bar position, in normal
“auto-trans” mode:
1. In the M/E or the PGM bank, start with the T-Bar at the bottom limit.
2. Press AUTO TRAN to begin the auto transition.
3. Press AUTO TRAN again (during the interval) to pause the transition at 50%.
Physical and virtual
T-Bar positions do not match. In this situation, the T-Bar has
no effect on the video unless you move it up to 50%, and match the physical
position with the virtual position.
4. Move the T-Bar to 50%. The T-Bar is now "live" again, and physical and virtual
positions are matched. You can move it up or down as required.
5. Move the T-Bar to 75%. The Transition LEDs match the position of the T-Bar.
Note
Using AUTO TRAN, you cannot return to the BG (or PGM)
bus, as you can with manual transitions, unless you manually
“match” physical and virtual positions, and return manually to
BG (or PGM). Refer to the “Physical and Virtual T-Bar
Position” section below for additional details.