Filter
Top Products
FSN Series • User’s Guide • Rev 01 341
7. Operations
Working with Memory Registers
11. Enter the desired description and press {Enter}.
12. Press ENTER on the Keypad. The register is stored, the Enables are set, and the
custom description is also stored. Above the
Keypad, the selected register
number and the custom description appear in the
Memory Display, adjacent to
the prefix “
STR:”
jÉãçêó=píçêÉ=kçíÉë
Please note the following important points regarding memory register storage:
• If you are in the midst of a Store procedure, the {Advanced} button is grayed out.
This feature prevents you from locking, unlocking, or deleting registers in the
midst of the procedure.
• At any point, prior to pressing ENTER, you can add or remove modules within a
pending
Store operation — even if the module buttons were not originally
selected in the Keypad’s
Module Section.
For example:
S You originally selected the M/E 1 module only, and you now wish to
add one or two
Aux routes to the register.
S You originally selected the M/E 1 and PGM modules, but now you
want to remove
M/E 1 from the register.
To add modules (prior to pressing
ENTER):
~ In the Enables Menu, press the light blue button for module you wish to
add (even if it was not originally selected). All Enables will be off initially,
but as soon as you toggle any Enable on, the associated module button
in the
Keypad lights. You can also press {All On}.
~ At any time in the pending Store procedure, simply light the desired
module button in the
Keypad. This action turn all Enables in the
selected module on, then you can “set” them in the normal way.
To remove modules (prior to pressing
ENTER):
~ In the Enables Menu, press the light blue button for module you wish to
remove, and press
{All Off}. The associated module button in the
Keypad turns off.
~ At any time in the pending Store procedure, simply turn off the desired
module button in the
Keypad. This action turn all Enables in the
selected module off — effectively removing the module from the register.
• Remember that once ENTER is pressed, the module’s contents are set — and
you can no longer add to the register. On recall, however, you can elect to recall
all of the register’s contents, or part of the contents by using your Enables.
Note
In Store Mode, the description will not appear in the register
table until
ENTER is pressed on the Keypad.