Filter
Top Products
FSN Series • User’s Guide • Rev 01 347
7. Operations
Selecting Clean Feed Outputs
pÉäÉÅíáåÖ=`äÉ~å=cÉÉÇ=lìíéìíë
The Clean Feed Setup Menu enables you to set clean feed outputs, and the source for the
ASSIGN button (in the control panel’s Aux Section).
S Prerequisites
~ Ensure that you are familiar with the Aux Section. In Chapter 3, refer to
the “
Aux Section” heading on page 91 for details.
~ Ensure that you are familiar with the Clean Feed Setup Menu. In
Chapter 5, refer to the “
Clean Feed Setup Menu” section on page 232.
Use the following steps to select clean feed outputs and the ASSIGN button source:
1. Navigate to the System Menu:
~ In the Menu Bar, press {Page} to display page 2 (if required). Then,
press the
{System} button.
2. Press {Clean Feed Setup} to display the Clean Feed Setup Menu.
3. To set clean feed outputs:
~ Press the blue {Clean Feed Outputs} button. The Palette changes to
the
Clean Feed Outputs flowchart.
~ Select the desired clean feed point for each output.
4. To set the ASSIGN button source:
~ Press {Assign Button}. The Palette changes to the Assign Button
flowchart.
~ Select the desired clean feed point for the ASSIGN button.
Note
Remember that only one clean feed source can be mapped to
the
ASSIGN button for all Aux buses. For example, you
cannot map “
Pre KEY 1” to Aux 1, and “Pre KEY 2” to Aux 2.