Filter
Top Products
430 FSN Series • User’s Guide • Rev 01
10. Updating Software
Updating FSN-1400 Software
réÇ~íáåÖ=cpkJNQMM=pçÑíï~êÉ
This procedure updates the FSN-1400 software to match the control panel software. This
step is required:
• After installing a new software file in the control panel.
• If the label “Mismatch” appears in the System Status Table on the System
Menu.
Use the following steps to update FSN-1400 software.
1. Ensure that the correct version of software has been installed in the control panel.
Refer to the “
Updating Control Panel Software” section on page 429 for details.
2. If you are not already there, navigate to the Software Menu:
~ In the Navigation Bar, press {System} to display the System Menu.
~ Press {Software} to display the Software Menu.
3. Press {Update FSN-1400}.
4. In the confirmation pop-up, press {Yes}. A pop-up alerts you that the update is in
progress.
5. When prompted in the pop-up, press {Restart} to restart the system.
6. When the pop-up clears, FSN-1400 software matches the control panel software,
and your system is fully updated and ready for operation.
`çåÇáíáçå~ä=réÇ~íÉë
Two conditional updates may be required if a software mis-match occurs in either the
Touch Screen or the control panel’s flash memory. If there is no mis-match, the buttons do
not appear.
• Press {Update Touch Screen} to update the software in the Touch Screen, if
required. Follow the directions on screen to complete the update.
• Press {Update FSN-150 Flash} to update the control panel’s flash memory, if
required. Follow the directions on screen to complete the update.
Update
FSN-1400
Important
If desired, press {Close} to clear the pop-up and display the
Software Menu. This action will not terminate the “restart”
procedure.
If the system fails to restart after several minutes, you can
return to the
System Menu and check the Communications
Setup Menu. In Chapter 5, refer to the “Communications
Setup Menu” section on page 194 for details.
Update
Touch
Screen
Update
FSN-150
Flash