Filter
Top Products
88 FSN Series • User’s Guide • Rev 01
3. Control Panel Orientation
Control Panel Descriptions
keyframe 2 to 1. Single keyframe DVE effects can only be mixed or
wiped up or down — they cannot be triggered.
Because DVE channels are assigned to keyers, there are three ways
that you can work with two-keyframe DVE effects:
• Mix or wipe only
Mix or wipe the DVE effect up or down (just like a normal key)
— without an effects trigger.
S Press KEY 1, press MIX (or WIPE), press AUTO TRAN.
• Mix or wipe plus trigger
Mix or wipe the DVE effect up or down — and simultaneously
trigger the effect.
S Press KEY 1, press MIX (or WIPE) + FX TRIG, press
AUTO TRAN.
• Trigger effect only
Trigger the DVE effect only, without a mix or wipe transition.
S Press KEY 1, press FX TRIG, press AUTO TRAN.
In Chapter 8, refer to the “Automatic DVE Triggering” section on
page 396 for complete details.
5) Cut
Press CUT to instantly cut to the layers that are enabled in the Next Transition
Section. For example:
S BG enabled — press CUT to cut from BG to PST.
S KEY 1 enabled — press CUT to cut Key 1 on or off.
S BG + KEY 2 enabled — press CUT to cut from BG to PST, and
simultaneously cut Key 2 on or off.
6) Auto Transition
Press AUTO TRAN to trigger an automatic transition, an effects trigger, or a
combination trigger plus transition — to or from the layers enabled in the Next
Transition Group. The transition uses the “type” of transition enabled in the
Effects Group, and the M/E’s current transition rate and curve.
For example:
S BG + MIX enabled — press AUTO TRAN to mix from BG to PST.
S BG + WIPE enabled — press AUTO TRAN to wipe from BG to PST.
Important
The following criteria must be met in order to enable the FX
TRIG button:
• One or two DVE cards must be installed.
• A DVE channel must be assigned to the keyer that
you wish to use.
• The DVE mode in the Key Menu must be “on.”
• KEY 1 and/or KEY 2 must be enabled.
• A two-keyframe effect must be loaded in the selected
DVE channel.
If any of these criteria are not met, the button will not light.
CUT
AUTO
TRAN