Filter
Top Products
FSN Series • User’s Guide • Rev 01 115
4. Installation
FSN-1400 System Connections
mçïÉê=`çêÇLiáåÉ=sçäí~ÖÉ=pÉäÉÅíáçå
The FSN-1400 is rated to operate with the following specifications:
• Input Power: 100-240 VAC, 50-60 Hz
• Power Consumption: 800 watts maximum
The FSN-150 is rated to operate with the following specifications:
• Input Power: 100-240 VAC, 50-60 Hz
• Power Consumption: 150 watts maximum
Each FSN Series component performs line voltage selection automatically, and no user
controls are required. The AC power cords must be accessible so that they can be
removed during field servicing.
Figure 4-10. Tandem Prong-type Plug
Warning
When the FSN-1400 or FSN-150 control panel is used in the
230-volt mode, a UL listed line cord rated for 250 volts at 15
amps must be used and must conform to IEC-227 and IEC-
245 standards. This cord will be fitted with a tandem prong-
type plug.
The rear panel ON/OFF switch does not disconnect the unit
from input AC power. To facilitate disconnection of AC power,
the power cord must be connected to an accessible outlet
near the unit.
Building Branch Circuit Protection (minimum requirements):
For 115 V use 20 A, for 230 V use 8 A.
Avertissement
La choix de la ligne de voltage se réalise automatiquement
par le FSN Series Transformateur Graphique. On n'a pas
besoin du controller usager pour la choix de la ligne de
voltage.
Warnung
Das FSN Series gerät mu beim Anschlu an 240V ~ mit einer
vom VDE auf 250V/10A geprüften Netzleitung mit einem
Schukostecker ausgestattet sein.