Filter
Top Products
90
8.11.10 Set-up of block (Step 9)
It is possible to set the block for each group as an
operation block. This operation block can be also
used for the charge calculation.
Set the block groups.
[Procedure]
1) Select a floor using the “
/
” button
From the Block Settings window, use the “
/
”
button to select the floor.
2) Click the group icon.
Select the Group icon to be added to a block by
clicking on it. More than one group may be
selected at one time. Click on a selected group to
deselect it.
(The selected icon is displayed with red frame.)
* The state changes from selected/not selected each time the
group icon is clicked.
3) Click [Block Set] button.
With the Group icon selected, click on the [Block
Set] button. A Block Settings and Naming screen
appears.
4) Select either New or Exist.
In the Block Settings and Naming screen, use the
option buttons to select either a new block name
setting or an existing block.
5) Enter a block name or select a block name.
To enter a new block name, just enter the name. To
work with an existing block, select the block name.
6) Click [OK] button.
Click the [OK] button after setting the block name.
The label “Block**” appears in the group icon.
(**: Block No.)
* Max. 2000 blocks
7) Repeat steps 1) to 6).
Set the blocks for the groups on each floor.
8) Click [OK] button.
When finished setting blocks, click the [OK] button.
* When the [Cancel] button is clicked, this setting is
terminated to return to the initial window.
Note:
• Block names may contain a maximum of 20 characters.
(These characters [ ' < > & “ ] cannot be used.)
• If all group icons are not assigned to a block, a warning message appears. Correct this error to
proceed.
• When using the charge function, groups not assigned to blocks will not show up in the charge
information. Be sure to assign all groups to a block.
• Basically, the operation block is the same as the blocks set in the AG-150A/G-50A browser.
The operation block set with the integrated software TG-2000A can extend over AG-150A/G-50
A
units, but in this case, individual block settings will be used in the AG-150A/G-50A.
Block Settings and Naming screen
Set-up of block screen
Name Change button
Release button
Block Set button
Group icon select/non-select state
di l