Filter
Top Products
61
8.4 Site Name Set-up
Set the site name which this integrated centralized
control software TG-2000A is installed.
Set the site name.
[Procedure]
1) Click the [Site name set-up] button.
Click the [Site name set-up] button in the User
Set-up Group in the Initial window.
2) Enter the site name.
Enter the name of the site on the site name set-up screen from keyboard.
3) Click the [OK] button.
When finished entering the site name, click the [OK] button.
* Click the [Cancel] button, the site name is left unchanged.
8.5 Password Set-up
The initialization password and maintenance password can be changed.
Change the password.
[Procedure]
1) Click [Password set-up] button.
Click the [Password change] button at the Initial
window user setup group. The New password
set-up screen appears.
2) Select the target to be changed.
Click and select the target to be changed.
(Password type)
• Initialization password (System
administrator password)
• Maintenance password (Maintenance
user password)
• Exit password (for quitting TG-2000A from
the management screen)
3) Enter the password at New password.
Set the password at New password.
4) Enter the password for verification.
When a new password was set at Step 2), set
the same password for verification.
5) Click [OK] button after finishing the setting.
Check the display contents and click the [OK] button.
* When the [Cancel] button is clicked, this setting is terminated to return to the initial window.
Note:
• Site names may contain a maximum of 20 characters. (Single quotations ['] cannot be used.) The
site name is reflected upon the start-up screen and version confirmation screen display.
Site Name Set-up
Caution
• Always memorize the new password. If you forget the password, you cannot open the Initial
window.
Note:
• When the Initial window is opened by initialization password, the Initialization, Maintenance, and
Exit password can be changed at the Password change screen. You should not use the same
password for these three settings.
• When the Initial window is opened by maintenance password, only the Maintenance password can
be changed at the New password set-up screen.
• The "Maintenance user" password is used for "Maintenance" on the initial screen, for changing the
maintenance user's password, and for "Charge set-up" on the Management screen.
New
p
assword se
t
-u
p
screen