Filter
Top Products
135
<Supplement>
The AG-150A/G-50A and PLC basically save the data for the past 62 days in a dated format for each
unit price.
(The accounting system of PI controller stores the operation amount/electric amount data for the past 62 days
on AG-150A/G-50A.)
Monitoring operation amount/electric amount data
[Procedure]
1) Click [Operation amount/Electric amount data
monitor] icon.
Click the [Operation amount/Electric amount data
monitor] icon of the maintenance group in the initial
window.
2) Select the button for the target to be monitored.
Click the target data's [Operation Amount] or [Electric
amount] data on the Operation Amount and Electric
amount Data Monitor Setting screen.
3) Set the interval to be monitored.
Use click and the “
/
” buttons to set the interval
the running data held by the AG-150A/G-50A is to
be monitored.
* Numbers can be manually input from the keyboard.
4) Set the additional unit
If there are additional units or WHM, select the “An
extension unit/WHM” optional button and click the
“Select” button.
When setting the additional unit, set the additional
unit and the installation date and then click the
[OK] button.
*
The monitor can be carried out in consideration of the
period before the installation.
5) Click [OK] button.
When setting of the operation amount/electric
amount data monitoring interval is complete, click
the [OK] button. The operation amount data
monitor confirmation screen appears.
* If the [Cancel] button is clicked, the settings are interrupted
and the screen returns to the Operation amount/Electric
amount data monitor setting screen.
6) Click [OK] button.
Confirm the monitoring interval at the operation
amount data monitor confirmation screen. After
confirmation, click the [OK] button. If it is determined
automatically that the monitor-prohibit time is
applicable.
When it is out of the prohibited time range, the
operation amount/electric amount data monitor is
started and the message "Please wait a moment"
is displayed on the screen.
After the monitoring is terminated, the screen
returns to the initial window.
* Since the monitor of the operation amount/electric amount
data requires time, wait for a moment until the monitor is
terminated.
<Caution>
Even if the operation amount data is monitored, it may not be executable in some cases due to the
following reasons:
• When the data has not accumulated due to a power shutdown for over 24 hours of the
AG-150A/G-50A
• When the data has not accumulated due to setting the time/date of the AG-150A/G-50A and
PC forward by over 24 hours
• When the AG-150A/G-50A is replaced due to AG-150A/G-50A, PLC or PI Controller (MCP),
failure
• While the current time is “22:00~0:30”, the monitoring cannot be performed.
When the operation amount data is monitored by the system (2000 units) for one month, it takes
approximately one hour.
Operation amount/Electric amount data monitor
confirmation screen
Operation amount/Electric data monitoring screen
Selection of an extension unit screen