Mitsubishi Electronics TG-2000A Air Conditioner User Manual


 
63
3) After completing the setting, press the [OK] button.
After fully completing the IP address set-up for the AG-150A/G-50A units, set the [OK] button, by
which the G-50A connection setting is completed.
* When the [Cancel] button is clicked, this setting is terminated to return to the initial screen.
Monitor the option function usage state and AG-150A/G-50A's version and serial No.
[Procedure]
1) Select the AG-150A/G-50A No.
Select the AG-150A/G-50A No. desired to monitor the optional function used with the “
/
buttons.
2) Select the [Monitor] button.
When the [Monitor] button located on the IP address screen of the AG-150A/G-50A is clicked, the
result is displayed.
Note:
It is necessary to set the IP address for the AG-150A/G-50A using the AG-150A/G-50A main
unit, initial setting Web or initial setting tool.
Note:
It is possible to monitor the optional function of the AG-150A/G-50A and to confirm whethe
r
the license desired to be used for the integrated software TG-2000A is registered (exists).
Web monitor : Required when the monitor operation is executed, using this
TG-2000A and the Web.
Annual/weekly schedule : Required when the schedule setting is used.
(Schedule)
Charge : Required when the Charge calculation (charging function) is
used. (It is also required when the operation time is used.)
Energy saving : Required when the energy saving function is used.
Peak cut : Required when the peak cut function is used.
Personal browser : Required when the personal browser function is used.
Sending error mail : Required when the error mail addressing is used.
(Mail) (It is prepared for service maintenance.)
PLC for general equipment : Required when the PLC for general equipment Ver. 2 is used.
Register the license number for the AG-150A/G-50A’s optional functions from AG-150A LCD
or the Initial setting Web.
Unless the AG-150A license for “web monitor” is registered, TG-2000A will not be able to
communicate with the AG-150A.
(Charge calculation)
(Monitor/Operation)
AG-150A/G-50A
select button
A
G-150A/G-50A No.
can be selected.
Each AG-150A/
G-50A setting
and display
A
G-150A/G-50A
name, installation
place, serial No. and
version can be
displayed. IP
addresses can be
registered in
TG-2000A.
Monitor button
A
G-150A/G-50A
optional function and
version information can
be monitored.
Option setting
display
Usage state and term of
A
G-150A/G-50A
optional function are
displayed.