Filter
Top Products
88
8.11.9 Set-up of icon arrange and name (Step 8)
Follow these steps to arrange group icons on each
floor plane, and enter the group name (LCD name,
short name, full name).
Set the group icons on each floor and set their names.
[Procedure]
1) Select the floor using the “
/
” button.
In the Group Icon Layout window, use the “
/
”
button to select a floor.
2) Select a group.
With the floor showing, click the IC group or LC
group to be assigned.
3) Select the location.
Move the mouse pointer to the location where the
group is to be assigned, then click that location. When
you click this location, the group name entry screen will
appear.
* The group icons can be neatly arranged by validating the grid.
4) Enter the group name.
Enter the LCD, short and full name for the group.
* There is no LCD name for the general equipments.
5) Select the display icon.
Set the display icon for each unit.
Select the icon with either cursor button
The user icon registration setting procedure.
Users can create an original icon and import the icon with
the image file selection.
Click the user icon registration button.
User icon registration screen will appear.
Select the icon No. (1～10)
Click the icon image file selection button and select a
prepared image.
※The image size is 50x40 pixels.
After the registration is completed, click the setting
button to save the change.
6) Repeat steps 1) to 5).
Layout the groups for each floor and enter their
names.
7) Click the [OK] button after finishing with group layout.
When finished with group layout and naming, click the [OK] button.
* When the [Cancel] button is clicked, this setting is terminated to return to the initial window.
Note:
• The following limitations apply to group names.
*
LCD name is a name displayed by G-50A main part. The minus sign is used for "-" in the LCD name.
LCD name: Up to 10 characters / Short name: Up to 8 characters / Full name: Up to 20 characters
The short names are displayed on the group icons.
Depending on the characters used, the entire 8 characters may not be displayed.
Single quotations [ ' ] cannot be used.
In the long name, these characters [ ' < > & “ ] cannot be used.)
• When the [OK] button is clicked without all group icons arranged for the floor, caution is displayed. If so,
execute the group placing and naming again.
• It is possible to use the group name as it is, which is collected from the G-50A. Note that the setting can
only be executed once.
* For the unassigned group, the operation block cannot be set for the following item. Note that the charge
calculation is not executed because the setting for the charge (calculation) block cannot be executed. The
charge block cannot be set unless the operation block is set. (It is possible to execute the normal operation
for entire buildings even if the group is not assigned.)
Floor Selection
Button
Displa
y
ON/OF
F
Button
Group Lis
t
Group Icon Layout screen
Upper field: Air conditioner group
Lower field: General equipment
User Icon Registration screen
Group Name Setting screen