Filter
Top Products
123
Set the representation group
[Procedure]
1) Select the representation group with the "
" button.
Select the representation group for each block selected with [Representation group mode] by
clicking on "
".
Finish the auto change over set-up.
[Procedure]
1) Click the [OK] button.
Click the [OK] button when finished with the settings.
Note: Mode change block in System-changeover function
Normally the air conditioner group belonging to one refrigerant system is one block. However,
if an air conditioner group extending over several refrigerant systems is set, all air conditioner
groups belonging to both refrigerant systems will be handled as the same mode change
block. (Refer to drawing below.)
Group 10
Group 5 Group 6
Group 7 Group 8
Group 9
Group 1 Group 2 Group 3
Group 4
Indoor unit
G-50A
Outdoor unit
Group 11
Mode change block
Mode change block
Mode change block
Representation group
selection field
Select the representation group when
using representation group control.