Filter
Top Products
67
(Supplement)
When setting unit system configuration for A-control units or K-control units, make the following
setting.
<Setting>
• Register AIC1 and AIC2 as indoor units.
• Outdoor units cannot be registered.
• Refrigerant system cannot be set.
• Make group setting.
<Setting>
• Register KIC1 and KIC2 as indoor units.
• Outdoor units cannot be registered.
• Refrigerant system cannot be set.
• Make group setting.
Value of Crank case heater is set separately.
Input capacity to KIC on the screen.
In this case, when KIC is in the same refrigerant system
like shown in the right figure, input it to KIC
whose address is the smallest.
(Input it only to KIC1 in the right figure.)
AIC: A-control indoor units AOC: A-control outdoor units
KIC: K-control indoor units KOC: K-control outdoor units
WHM for
AOC
AIC1
AIC2
A-control unit
WHM for
KOC
KIC1
KIC2
WHM for
KIC
K-control unit
(Measures the power
consumption of indoor
and outdoor units)
Note:
*The apportioned electric power calculation function cannot calculate the amount of power
consumption by each individual air conditioning unit.
To measure the electric power consumption of each individual A-control unit, install a watt-hou
r
meter for each unit.