Filter
Top Products
70
This group setting screen displays the number of groups and number of indoor units which allow
the GR, SR, AN, and SC to be newly organized.
Table: Number of management groups and number of indoor units
Symbol Equipment name
Number of management groups and
number of indoor units
GR Group remote controller 8 groups, 16 indoor units
SR System remote controller 50 groups, 50 indoor units
AN ON/OFF remote controller 16 groups, 50 indoor units
SC System controller 50 groups, 50 indoor units
Change the group No.
[Procedure]
1) Select the cell of the group No. displayed.
Click the cell desired to change the group No., and the
group No. change screen is displayed.
2) Change the group No.
Use the keyboard to input the group No. to change.
* Group No. setting range: 1 to 50
3) Select the [OK] button.
Click the [OK] button after changing the group No.
If there is a duplicated group No., an error message is
displayed.
Note:
• When the group setting change screen is changed, it is possible to reflect the changed contents
on the AG-150A/G-50A system.
• It cannot set the indoor unit (M-NET type), K-control unit, A-control unit, DIDO controller and
LOSSNAY for the same group.
• Since the number of groups and the number of indoor units connectable to the GR, SR, and AN
is limited, set the group corresponding with such limitations.
• DC (DIDO controller) cannot connect with RC, GR, SR, AN and SC.
Note:
• This group setting screen displays the number of management groups and number of indoor units
for the system controller (GR, SR, AN, SC) limited when the group is newly organized.
• It is possible to use the group organization as it is, which is collected from the AG-150A/G-50A.
On/off controller (AN), etc., for instance
Note:
• This function is used to change groups in which a sub system controller (GR, SR, AN, SC) is
selected. The group remote controller, system remote controller and ON/OFF remote controller can
control the groups that can be set with the address 200 value.