Filter
Top Products
66
Change the unit configuration.
[Procedure]
1) Select the AG-150A/G-50A No. with the “
/
“ buttons.
In this case, use the “
/
“ buttons to select the AG-150A/G-50A No. desired to change the unit
configuration.
2) Delete/add the unit icon.
Unit icon deletion: Click the unit icon to be deleted.
Unit icon addition: Click the unit icon to be added from the selected unit icon column to set it to
the selected state.
(The symbol of the selected unit is displayed by the pointer.)
When the address column to be added is clicked, the unit icon is displayed.
Table: Icon symbol and unit name
Icon Name Address range
IC *1 Indoor unit
LC LOSSNAY
FU OA processing unit
KIC “K” Control Units
AIC “A” Control Units
DC *2 DIDO Controller
MCT AI controller
MCP PI controller
1 to 50
OC Outdoor unit
BC BC controller (main)
BS BC controller (sub)
OS Subsidiary outdoor unit
51 to 100
RC ME remote controller (compact remote controller) /
LOSSNAY remote controller
101 to 200
SC System controller (Including GR, SR, and AN)
GR Group remote controller
SR System remote controller
AN On/Off controller
201 to 250
KA K-transmission converter (201 to 250)
TR Central controller (MJ-103) (201 to 250)
G-50 Central controller AG-150A or G-50A (0, 201 to 250)
?? Unconfirmed unit (1 to 250)
*1: Two or more addresses may be assigned to some of the large-capacity indoor units.
*2:
1 contact point for DIDO Controller is converted to 1 unit. Up to 50 units are connectable to each AG-150A/G-50A.
3) Select the [OK] button.
After fully completing the unit icon change, click the [OK] button.
Note:
• When the system information is collected from the AG-150A/G-50A, all the SR, GR, and AN
display "SC".
It is possible to change the icon to that of the system controller actually connected. When the
icon is changed, it is possible to display the unit in which the error occurred with the type easil
y
discriminated.
• Delete the "??" icon displayed, and set the original icon. Note that it is unable to advance to the
next step if the "??" icon exists.
• If the system differs from the actual system, restart the AG-150A/G-50A or check the ai
r
conditioner system.