Filter
Top Products
65
8.7.3 Unit composition set-up (Step 2)
It is possible to confirm and change the configuration of the unit in each AG-150A/G-50A.
Confirm the unit configuration.
[Procedure]
1) Select the AG-150A/G-50A No. with the “
/
” buttons.
In this case, use the “
/
“ buttons to select the AG-150A/G-50A No. desired to confirm the unit
configuration.
2) Select the [OK] button after checking the unit configuration of each AG-150A/G-50A.
If it is not necessary to change the unit configuration of each AG-150A/G-50A when it is checked,
click the [OK] button. *When the [Cancel] button is clicked, this setting is terminated to return to the
initial window.
※In the case of DIDO controller(DC)
When the address setting is completed, the contact number
screen will appear.
Check the checkbox corresponding to the contact number
to be used.
※Contact number is used as a number for general equipment connecting
to DC.
※ In the case of PI controller (MCT)
When the address setting is completed, the channel number
selection screen will appear.
Check the checkbox corresponding to the channel number to
be used.
Unit configuration address setting
Unit configur
a
-
tion tabl
e
:
Displays the system
configu
ration unit o
f
th
e
A
G-150A/G-50A
-
concerned.
Selected unit icon :
Displays the icons (symbols
)
such as the indoor unit, outdoo
r
unit, remote controller, system
remote controller, etc. and thei
r
names.
AG-150A/G-50A
Selection :
Select the
A
G-150/G-50A No.
Contact Number Selection screen
Channel Number Selection screen